|
| Installation |
| The
AquaCal heat pump is installed right into your existing
pool plumbing configuration, after the filter and
before a chlorine generator, if you have one. |
| PHYSICAL
PLACEMENT, OUTDOOR |
PHYSICAL
PLACEMENT, INDOOR |
|
|
|
|
|
PLUMBING
REQUIREMENTS |
| Minimum/Maximum
water flow rates: 5,6 - 15,9 m3/h |
| Spring-check
valve bypass required if pump > 2HP |
| Typical
pool with flow rate < 15,9 m3/h |
| Typical
pool with flow rate >15,9 m3/h |
| Pool
with spill over spa, 1 pump system |
| Pool
with spill over spa, 2 pump system |
| Heatpump
with solar panels |
| Heatpump
with gas heater back-up |
| Multiple
heatpump installation |
|
ELECTRICAL
REQUIREMENTS |
| Reference
Equipment Data Plate |
|
|
